Lze tak doporučit s upgradem počkat, až budou problémy vyřešeny, a to i v případě, že gigasety nemáte nebo dokonce VoIP vůbec nepoužíváte.
Jedna citacate z fóra microticu. https://forum.mikrotik.com/viewtopic.php?t=171035
Jiný stěžující:It is not apparent when using TCP connections and services that use a lot of buffering (e.g. Youtube), but when using a UDP stream or a TCP connection with little buffering there are regular cut-outs of up to a second in the connection.
That makes it unusable for e.g. VoIP or some of the meeting software in use in the world today.
While I have seen this happen before on certain combinations of releases and devices, this combination worked fine on 6.47 and is now severely affected on 6.48.
The signal is strong, the devices are only about a meter apart. But the connection appears to stall.
(I used a website that allows to test for packet loss and jitter, and it clearly shows the issue)
Další:we are experiencing similar problems, with CCR1016-12S-1S+ , since upgrade to 6.48 .
SIP packets randomly disappear, mainly Siemens Gigaset A510IP A540 IP A690 IP affected.
But RTP (UDP stream) also affected randomly the uploading (going out to internet) packets losts.
Problém je, že se to chová poněkud záhadně a nahodile, a tak nemusí nikoho napadnout, že je to tím, že jeho značkový router má jen děsně zabagovaný nový firmware. Je tak snadné s tím strávit celý den. Na fóru MicrotTiku jsem četl o jednom případu, který s tím trávil celý týden. (pokoušel se třeba vyměnit gigaset sluchátka za jiné )I experienced the same SIP problem with my Siemens handsets A540, went back to 6.47.8 to fix the problems, spent about 4 hours troubleshooting, I have logged a support call with mikrotik,
hopefully others will also log faults to prioritize the fix